Measuring for Recess Fit
-
Measure Recess
Using a Metal Tape measure, take all your measurements in millimeters (mm) from one side of the inner wall to the other side to side.
-
Measure Width & Drop
Measure the width and drop of where you’d like your blind to be. It is recommended to measure the width in three (3) different spots (top, center, bottom) and use the smallest measurement as the width.
-
Important Information
- Do not make any deductions of the measurement, we will take care of this in the manufacturing process
- On all blinds when we manufacture them we shall make a small deduction of 2mm from the width, and up to 10mm from the drop to clear the side and the bottom of the window recess allowing correct operation of the blind without interference.
Measuring for Face Fit
-
Measure Face
Using a Metal Tape measure, take all your measurements in millimeters (mm) from one side of the inner wall tot he other side to side
-
Measure Width & Drop
Measure the width and drop of where you’d like your blind to be. It is recommended the blind overlaps the window by at least 50mm to 100mm on each edge depending on the space you have. If you have an architrave we recommend measuring from outside of architrave to outside of architrave.
-
Important Information
- Do not make any deductions of the measurement, we will take care of this in the manufacturing process
- On all blinds when we manufacture them we shall make a small deduction of 2mm from the width, and up to 10mm from the drop to clear the side and the bottom of the window recess allowing correct operation of the blind without interference.
Read our next step